Metallic Snowflakes

Hello Stampers ~ how about some Metallic Snowflakes today using white, silver, and gold?

Zoie goes to the pediatrician today and I am hoping they will let her go back to school.  I know she will have to see an orthopedic doctor but I think that will be a formality.  I have a lot to get done in the next few days so I really need my time here without any distractions.  I have quite a few videos to make and it is much better if no one is here when I do that.

I checked out my challenge blogs as it has been a while since I played along with some of them.  I found a great sketch at Freshly Made Sketches.

 

 

 

 

 

 

 

 

 

 

I really liked this sketch but I did take some liberty with the layout.  I began by embossing a Whisper White panel with the Winter Wonder embossing folder.  A strip of the Year of Cheer dsp with the silver and gold snowflakes was cut to go across the lower part of the panel.  A half of a silver Foil Snowflake was used for the teal circle in the sketch.  This was attached to panel using tear & tape.  The strip of dsp was added on top hiding the bottom edge of the snowflake where the tear & tape was used.  To finish the card and address the white circle in the sketch, I added a gold foil paper swirl using the framelits from the bundle.  I also used some Dazzling Diamonds glimmer paper to cut out a snowflake.  This was added on top of the foil swirl.  My clean and simple Metallic Snowflakes card was complete!

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

inside of card and envelope

 

 

 

 

 

 

 

 

 

 

Stampin’ Up supplies used for my creation

 


Thanks for visiting me today and I hope I inspired you.  Did you see I used some of the Dazzling Diamonds glimmer paper on my card today?  Make sure you check out my Creations of the Month as I used that same glimmer paper in 3 of my cards!  You don’t want to miss this class!  Have a Terrific Tuesday and take some time to create your own Metallic Snowflakes card!

Save

Save

Leave a Reply

Your email address will not be published. Required fields are marked *